DOWNLOAD PDF

The EuroStopa dimensioning module was created to design shallow foundations according to PN-EN 1997-1 Eurocode 7 in the R3D3-Rama program in the complex load state. It is produced in the form of an installation integrated in the R3D3-Rama program for static calculations, which requires a separate licence.

 

 

At present, R3D3-Rama and EuroStopa can operate in two configurations:

  • Separately, as a program for static calculations only (the EuroStopa module works only in the demo version) – A licence for R3D3-Rama is required.

  • In connection with the EuroStopa module as a program for static calculations and dimensioning of spot footing – a licence for R3D3-Rama and EuroStopa is required.

 

 

This module expands the capabilities of the ArCADia-RAMA program with advanced functions.

Advanced features of the EuroStopa module:

In general, the program can perform the following calculations and verifications:

 

  • The verification of the load bearing capacity of soil in both directions, at the foundation level and the upper surface of each soil layer for all loading scenarios according to the PN-EN 1997-1 Eurocode 7 standard.
  • Verification of the standard condition regarding the size of an eccentricity.
  • The dimensioning of a foundation block for bending induced by soil pressure, calculated for extreme stress in the x and y direction (acc. PN-EN 1992-1-1 Eurocode 2), including  verification of the structural conditions for minimum reinforcement and proper selection of bars.
  • The rotation resistance for successive loading scenarios is verified.
  • The punching resistance is verified in characteristic cross-sections of a spot footing.
  • Calculation of the mean primary and secondary settlement of a foundation block in a subsoil layer for all loading scenarios using the stress method (compliant with the Eurocode).
  • The dimensioning of vertical and horizontal reinforcement is performed for bell footing, including proper selection of bars.

EuroStopa

 

Design shallow foundations in the complex load state

             DOWNLOAD FREE TRIAL

Apart from a wide range of calculations, the module offers the following features:

 

  • It incorporates a piezometric ground water level.
  • It allows for the consideration of additional eccentricities, when reactions in foundations are located.
  • It allows the calculation of the vertical reaction of a support (Winkler's coefficient).
  • It is ergonomic and simple to use.

 

€320.00

HOME  |  PRODUCTS  |  COMPANY  |  CONTACT  |  FOR RESELLERS

Copyright © 2019 ArCADiasoft